Tractor Talk Discussion Board |
Re: best way to split m
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on January 11, 2001 at 16:24:04 from (209.130.137.59):
In Reply to: best way to split m posted by jimmy stewart on January 11, 2001 at 13:46:16:
I split my 43 M a few years ago to change the rear seal. You can split it without taking out the clutch but its difficult to line it up when putting it back together. I would recommend removing the belly pump, if you have one and remove the clutch. I blocked up the rear half of the tractor using cement blocks and used my neigbors tractor and loader to work the front end. I also had a hydraulic floor jack so I could make small changes in height on the rear half. You don't say why yo have to split the tractor but I would recommend changing the rear oil seal while its apart. The only extra work at this point is to remove the oil pan while the tractor is still safe to lay under. Good luck - its not brain surgery but it is a lot of work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|