If it appears everything's as advertised, and everything works, buy it. I'd been a Ford PU man from age 18 when I bought my first, drove Dads' before that. Still have both a '77 & '91 F150. That being said, my best first choice would be a Ford with a Cummins diesel engine. I bought my '98 Dodge Ram 3500 in July of '03. I love the Cummins part of it, and put up with the rest. I over torqued the clutch once, tore the center right out of the clutch plate. Something to be careful of. If the deal with the nut on the fifth gear shaft hasn't been done, you will be doing it at some point. You can just figure on that being a given, but it's not a bad job, tranny doesn't have to be pulled, and after market nut up grade solves problem permanently. Any good transmission shop will know all about that deal, and with 180K miles on the truck, it may very well have been done already. If you're driving along, and suddenly lose fifth gear, you'll know that's what's wrong. Any other complaints I have with my truck are all rinky dink Dodge aggravations, like Chrysler products have always had. Check things like all of the light lenses and housings, and the grill. All are 100% plastic, attached with 100% plastic fasteners, and are prone to breakage and failure. If they're not solid, negotiate them into your offer. Just things to look at and watch out for. I had a lot of friends driving Dodge Cummins PU's that were getting along with them reasonably well before I bought mine. The conversation that finally nailed it with me was when I was at a salvage yard getting some used parts for a wrecked car. I asked the owner, who I know pretty well, for his opinion on Cummins versus Powerstroke. He said, "The requests I get for Powerstroke engines and parts out number Cummins by at least five to one. Whats that tell you"? At any rate, even if you have to give the full price, it's a WAY better deal than the '84 Ford, IMO. Good luck!! :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
