Posted by tennhillbilly on October 14, 2009 at 19:23:53 from (75.136.207.35):
In Reply to: Farmall M clutch problems posted by tennhillbilly@hotmail.com on October 13, 2009 at 06:29:02:
Update on
farmall M with clutch problems Today we removed the clutch, pressure plate and checked everthing we could think of using some of the sugestions on here and our own knowledge. we do have some wear in the linkage forks,and the cross shaft in the clutch housing but I have another M with similar wear and the clutch works fine on it. We shimed the pressure plate out about 50 thousands and now after several seconds with clutch pedal pushed in you can shift it into gear.I know this didn't fix the real problem but it is liveable for now. MANY THANKS FOR ALL THE SUGESTIONS YOU GUYS ARE VERY HELPFUL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
