Call it whatever you wish.....what you are doing is more or less making charcoal and burning the gas produced in the process.
When coal is converted into coke.....the "coking" process produces..(duh!) coke gas. This gas is used to fuel blast furnaces, fire boilers, etc.
When coal is coked and wood is converted to charcoal, you heat them up in special ovens and seal off any oxygen....if you don"t....the coal or wood burn up. This starving process produces the gases as the volatile elements are driven off. If you ever build a fire in a stove.....especially with coal and close the damper (cutting off the air)....you begin a crude coking process and that green looking coke gas will ignite like gasoline if you suddenly open the stove door.....ask me how I know....hehe!
Of course internal combustion engines have been modified to burn these crude gases.....but I"d be more interested in making an engine run on home distilled alcohol than on wood gas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.