|
Tractor Talk Discussion Board |
Re: Re: Re: Little trick I learned...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pete in Post FAlls on January 01, 2001 at 20:33:12 from (64.12.105.28):
In Reply to: Re: Re: Little trick I learned... posted by jld on January 01, 2001 at 14:08:23:
I have LOTS of experience with a Needle Scaler (AKA Needle GUN, one of the nicer names). Harbor Freight has one. I used one for years in the Navy to remove paint from metal. Worked OK after I started using ear plugs AND "Mickey Mouse" ears (AKA Ear Muffs). Read that LOUD. There is another implement of destruction called a "Knuckle buster" that had three larger strikers that came out of the pneumatic controller. We'd typically do most of the paint removal with the knuckle buster (especially the deck paint/sand mixture) the fine stuff with the needle gun and then wire brush/sand smooth, prime and paint. Brings back memories I thought I'd regressed! Pete in Post Falls
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
