|
Tractor Talk Discussion Board |
Re: two questions/ overrun pto att. ford rims
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on June 05, 2007 at 07:38:57 from (4.244.186.95):
In Reply to: two questions/ overrun pto att. ford rims posted by BLW on June 05, 2007 at 06:57:33:
ORC is held on by a roll pin, 2X5/16 if I remember right. You have to remove the grease zirk and the plug to see how to install the pin. The outer rims will fit from the 2N and the 8N not sure on the other tractor. All rims from the 9N up to the 3000 series will fit on all of the model or most of them unless they have the power adjust rims on them
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|