Posted by DH in Carolina on September 23, 2009 at 05:30:06 from (207.144.236.108):
In Reply to: Second time around posted by LOU from Wi. on September 22, 2009 at 18:12:40:
Looks good but: If that is a galvanized pipe ell on the hydraulic hose you need to replace it with a hydraulic fitting. Only rated for 150lbs pressure. Also put some bed guides on the front of the bed to center it on the frame rails when it is lowered. They will keep the bed in place around curves and on hill sides. Next put some breather screens in the unused port of your cylinders to keep trash out. Only raise bed on level surface with double cylinders. If on a slope and loaded the lower side will take more pressure to lift. The cylinder on the upper side will twist the bed as it will raise higher. Saw one loaded with dirt turn over because of this. Bed twisted and rolled over.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
