Kyrr, soundguy is right. BTW, he helped me on pressure testing my hyd pump. Check the archives with his "name +pressure test".
Also, in my book it describes a gauge, I bought at the hyd shop for about 20 bucks. and relief valve setup to test the pump while it is on the tractor. The picture is unreconizable because it is so dark, or I would send it to you.
anyway, I plumbed the gauge (with a "tee") into the allen head bleed screw in the pump body. next the valve, (a brass gate valve for my water hose), attached to that was a hose (clear tubing, so i could see any bubbles) dumped it into the fill hole on the rear axle.
MAKE SURE THE VALVE IS OPEN BEFORE YOU START THE TRACTOR!!! TRIPLE CHECK THIS!!!
at a good idle, somewhat warmed up, start closing the valve. watch the pressure gauge, mine went to 1800 psi before the system relief valve opened. The pump checked out okay. I don't remember what the specification is. maybe 2200 output from the pump itself. but it was enough to let me know that the pump was good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
