Posted by Mike M on September 19, 2009 at 16:18:57 from (72.251.100.203):
Here are some prices from todays auction in Ohio. All John Deere 2 cyl. and all "restored" they were nice , but I could still find some issues with most of them. I am just fussy and like paying more attention to little details compared to most. I was VERY surprised to see the 40-W model sell so cheap compared to other models they made far more of. Maybe they are not well know of only less then 1800 being made.
40-T with WF $4,500 40-V $10,000 40-U $5,100 40-H still original paint $6,600 40-H $12,000 40-S $4,500 40-W $3,000 420-W $4,400 420-H $8,250 phase 1 420-H $15,000 phase 3 320-S $8,700 MT $3,100 L w/cult elect start $4,900 styled D original paint $3,000
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.