Posted by LOU from Wi. on September 17, 2009 at 07:33:18 from (174.124.74.242):
In Reply to: Re: Here tis (PICS) posted by T_Bone on September 16, 2009 at 19:36:33:
Thanks for the swell imput. Didn"t use ball valves cause we thought they just might jar closed. After reflection don"t think that would happen though and would be a little difficult to tie em in with the frame bracket that supports the valves and tubing. Availability of space had a lot to do with the choice of valves.Could have used just one valve ,as Alan from Neb.pictured showed. Thought about that and decided that two valves would allow water shut off with out pluging line from the block in case we had to remove the cab for any reason. Yep used Anti -seize on al the bolts. Thanks for your comments. LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
