Posted by trucker40 on September 11, 2009 at 19:48:53 from (69.155.104.135):
In Reply to: Re: Stitch vs Welding posted by T_Bone on September 11, 2009 at 19:01:25:
He is right about not cutting cast iron with a torch or not very well,which reminds me that if you have a broke off bolt in a casting you can torch it out,tap the threads and put a new bolt in.You have to be good with a torch but its possible and it wont cut the cast threads maybe.Anything can happen in a situation like that,but I have done it many times on Dayton wheels when a stud broke off in the cast hub.Also if you get cast hot enough anything is possible.Usually a torch and cast iron needs some knowledge of what you are doing,and could have something happen that you dont expect like breaking if you heat it up too hot in one place.I bet you could take a torch and turn one cast piece into two in a short period of time,cutting might not be the best word to describe it,but its possible to break it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
