Clodbuster said: (quoted from post at 19:15:21 09/10/09) It could be that the operator is pulling the pto knob up too quickly when starting the pto.
Idle the engine, ease the knob up slowly and watch the pto shaft slowly start to turn and gently pull it to the top position.
These tractors will snap the pto in too quickly if the engine is sped up or it you do it too fast.
We have run these good ole tractors forever but if the operator is in a hurry or careless they will break the key.
We never break a key but my Dad had an employee years ago that would break one about every day no matter what you told him or showed him. He did not last long!
By the way, my 2290 hit the dyno at 159 hp.
Thanks for the advice, but there are no bad operators involved with this tractor. We wish the answer was that easy. We looked into getting the woodruff key grove on the shaft and gear machined to the next size bigger and found out they are made of a very hard steel that would be very expensive to get done. New gear and shaft is around $660. New hardened keys $6 for 25 of them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
