Posted by kyplowboy on September 10, 2009 at 18:35:14 from (98.93.105.124):
In Reply to: cattle fence posted by Mark W. on September 10, 2009 at 09:29:10:
My perimeter fence is 3 strands of smooth HT. One at my knee, belt and chest. Bull and wean'n pin is 6 strands about 8" apart. Never had a calf get out of the pen when it tested over 3kV. Never had any momma cows fight perimeter (or single strand of barb wire cross fences for that matter) when it tested over 1.5kV. Baby calves won't fight perimeter over about 2 or 2.5kV.
Unless you live in a very very arid area hot and not hot wires running parrallel are not a good idea in my mind. The only reason I would do it is if I HAD to use the not hot wires as the ground. One, with that system cow has to touch two wires at the same time to get hit. With all hot she just has to touch one wire and have one foot on the ground. Two, with some hot some not every time a tree limb falls making wire one touch wire two you are going to loose alot of voltage. Also with this set up a stray piece of baler wire or a loose jumper that comes loose will kill the whole system and can be a PIA to find, even with a good tester.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.