Posted by dave2 on August 26, 2009 at 19:45:24 from (139.139.35.70):
Try to keep this short. Agreed to take all hay (post the other day) from my buddy/neighbor. Just paid the roller price for the rained on stuff. Can't/won't use it myself so offered it to another neighbor (21 rolls) for 6 good ones. He couldn't use it but said that a farmer lost everything in a fire last week a few miles away and I should go to another neighbor who is a friend of the guy to get his number. Went there and the guy told me that his buddy didn't need any feed but he'd buy it from me. I made a rule last year that I wouldn't deal with this guy so decided to just put an ad in the paper. Ran into the 1st guy on the way home and told him what was said. He came by the house a little later with a phone number. I called the guy and he was glad to hearfrom me. Said I should tell his buddy what I have and make the deal with him. Told him what his buddy said and that I'd rather deal with him directly. He asked what I wanted and, figuring he was in a pinch, asked him what he wanted to pay. Said his buddy was charging him 28 bucks a roll for everything he could find for him and he'd pay me the same.
Couldn't resist, I'd just paid 150 bucks for the 21 rolls (7+/- a little ea). His buddy was going to pay me the same 7 bucks and charge him 28.
Couldn't resist the opportunity and told him that was too much, I'd give it to him for what his buddy was going to pay and he could send a few steaks now and then. Gave up some bucks but shedding a little light on a crook was priceless.........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
