Posted by kyhayman on August 24, 2009 at 07:32:06 from (75.105.0.38):
In Reply to: Question on hay fires? posted by Larry here on August 23, 2009 at 21:24:40:
Cody gives you a good explanation of the process. Heating is part of curing. Microbes continue to consume oxygen and plant nutrients until the moisture content drops below the point they can reproduce. Just like with corn or soybeans. Put them in the bin too hot and they will spoil. The heating from the hay can ignite dry hay either in the same bale or adjoining bales. Same can happen with hayledge if the silo isnt airtight. Makes a nasty silo fire.
Density makes it worse, since moisture and heat have a harder time getting out of the bale. Thats why we want hay for round bales DRIER than we want hay for small square bales at baling. Large square bales have a higher density still. With round bales, you can get away from the fire risk by storing outside where heat can dissipate. Inside a barn tightly stacked round bales are a great fire hazard if they are too wet going in. A lesser risk is given the same moisture a barn stored stacked round bale can mold when a loosely stacked small square in the same barn wont.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
