|
Tractor Talk Discussion Board |
Re: Top Link
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLight on December 11, 2000 at 09:08:04 from (209.226.181.161):
In Reply to: Top Link posted by Steve M on December 10, 2000 at 19:58:06:
You can get a short one at Ford tractor dealers for 39$ Can.
Or do what I did. Get 1in threaded rod and
2, 3in long nuts. (usually sell right beside rods) The rod will be either 4ft or 3ft long and u
can get them at the larger hardware outlets.
With some scrap 1/2 X 2.5in plate,3/4 in drill and welder you can make it up turnbuckle fashion.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
