Re: How to remove keyways from shafts

Posted by MikeH-Tx on December 08, 2000 at 10:12:31 from (192.55.23.50):

In Reply to: How to remove keyways from shafts posted by Rick from Paso on December 06, 2000 at 20:45:19:

Rick, I just had to do that on the belt pully shaft of a Farmall F12 I am working on. The half moon woodruff key was sheared so that it barely was above the shaft. I ended up heating the key with a torch, and then used a screwdriver to get under one side and slide it out. The rust that was holding it onto the shaft also insulated the key so that as it was getting cherry red, the shaft was still much cooler - no glow at all. Worked in just a few seconds.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: How to remove keyways from shafts Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]