Posted by Don-WI on August 20, 2009 at 13:24:59 from (72.135.121.207):
I've had something in my eye since this weekend, finally gave in and went to a doc yesterday. She couldn't get it, so got me in to a specialist just down the road from work (got luky I guess) and today I took a break from work and went in. Only took about 15-20 minutes to be in and seen.
Funny part was, after it was all done, THEN I got a little light headed and dizzy with the cold sweats and whiter than a ghost. I sat there for another 1/2 hour to get my color back. Overall not too bad, my eye is just a little sore now. Doc said it looked like some metal that was starting to rust. After she got the peice out, there was a little bit of stuff left on my eye so she used some little buffer almost to get the rest of it out. Eye will be fine, just gonna take a day or 2 to heal I guess.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.