|
Tractor Talk Discussion Board |
Re: Re: Mystery Hole in carburetor mounting flange --- WHAT'S IT FOR ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by I FOUND OUT - Alberta Mike on December 03, 2000 at 19:59:16 from (209.115.159.128):
In Reply to: Re: Mystery Hole in carburetor mounting flange --- WHAT'S IT FOR ??? posted by TomH on December 03, 2000 at 19:49:13:
No, the hole isn't threaded - but anyways, I took the carb over to my neighbour and he figured it out. Anyways, the brass at the bottom of the hole is a brass PLUG (not a jet or an orifice) and the hole is actually one of the larger holes that are drilled so that other smaller drills (for drilling the various channels within the casting) can be used. After the small hole is drilled, the large access hole is plugged up. He showed me a number of other locations on the carb where these brass plugs are, only they are at the surface of the casting, not deep inside the larger hole. Interesting stuff those carbs.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
