Posted by John A. on August 09, 2009 at 21:12:33 from (76.1.122.170):
In Reply to: Geeze! posted by Allan In NE on August 09, 2009 at 16:18:04:
Allan By the looks of that pic, it looks looks like Work! We always stored our duals at our old storage barn. Kept a 3 ft piece of 2x6 that had another 2 ft piece of 2x6 nailed to it in successive fashion. Backed the tractor up to the door where the duals are, like 10 feet or less, then up on the two 2x6s till the tractor lifted just a little, Just high enough to roll the dual up to the hub and lean the dual on to, then pop it on the hub , line up the holes, by rotating the tire a little with a 6 ft piece of 1&1/4 pipe, stab the mounting bolts, tighten the bolts, repeat the process on the other side. My best time was 10 minutes start to finish, (balls to the wall) more like 20 minutes or slightly less was the norm. Maybe something like this process above might help, I don't know! Just be very careful!! I did loose a, 18.4x42 one time. I slipped for it was wet and slick , that dual got away from me an wound up on me at about waist high, it was all I could do to get out from under it. be very careful. Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
