Posted by wyley on August 07, 2009 at 18:04:34 from (72.145.167.101):
In Reply to: 99 Olds Brakes posted by Mark-IA on August 07, 2009 at 16:33:39:
will the brakes pump and hold psi, if not possible bad m/cyl. remove m/cyl and try to bleed on binch, make sure the plunger is not stuck at bottom of bore. when bench bleeding make sure to keep both brake line outlets coverd and let the psi off gently and cover then before releasing the plunger. after bench bleeding reinstall m/cyl connect lines and try bleeding againg, rember to start at rt rear, left rear, rt front and left front, do not let the resivor get low of fluid keep about 1/2 full at all times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
