Posted by M Nut on July 26, 2009 at 19:45:05 from (170.215.14.107):
Needing help again.
886 hydraulics are not working. Was cutting hay and it stopped lifting the discbine. Stopped and checked oil level, seemed like it was ok but added a couple of quarts to see if it would help. Hydraulics started working and finished cutting the field. About 20 minutes later switched over to the round baler to bale a different field, and baled a couple of bales and the hydraulics wouldn't open the baler gate. Hydraulic lines just stayed limp. After the tractor sat about 30 minutes, I could bale about 2 or 3 bales again before the hydraulics quit working again. At that point I ended up switching my baler monitor to a different tractor and finished up that way. When the tractor was above an idle I could hear the pump whine a bit which I had never heard before. I'm thinking start by replacing the hydraulic filter (it was supposedly replaced this past spring)? Any other possibilities? Hydraulic pump getting weak?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
