Posted by kootenay farmer on July 26, 2009 at 19:38:10 from (24.66.233.27):
i picked up a small grain grinder i believe that would have been powered by a small gas engine. i am trying to determine if i can mill flour with it or does it just roll grains.
it has no name tag on it, it is all red, with a bell stamped on the front with the number A60 on the side. it has a small hopper ontop that holds grain, there is s small door/gate that is used to control flow. the grain runs inside a burplate attatched to the shaft that rubs up against the bak wall. The flour? then falls out the bottom down a shoot. you can adjust the pressure on the bur plat with a knob on the outside that pushes a ball coated in grease against the bur plate.
will this unit mill grain into flour?
i want to find out before i go through the effort to clean up, build a sub frame and repower with electric motor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
