Depends on what you mean by "push." Splitting power is determined by PSI and the diameter of the cylinder. More PSI gives more force and so does more surface area on the piston in the cylinder.
Raising PSI takes more horsepower. Increasing cylinder-bore size takes less horsepower, but also slows it down.
So, it's a toss up. I've got three log splitters. Two self-powered, and one run by a Price PTO pump on a 33 horsepower tractor, hooked to a 4" diameter cylinder. My 28 horse tractor can run all day splitting hard maple and red oak with the engine idling, and great cycle-time. So, obviously, I could do it with a smaller tractor.
Keep in mind that Prince makes PTO pumps in four different sizes. Mine is the biggest at 9.9 cubic inches per revolution. The smallest one is only 3.6 cubin inches per rev. Remember that you need a big pump since the PTO runs so slow. Most standard pumps are rated at 2000 RPM, not 545 RPM.
My pump puts out 21 GPM at 540 RPM and 2000 PSI. It needs 32 horsepower to make 2000 PSI (which only happens in the hardest wood). Needs 24 horse at 1500 PSI and 16 horse to make 1000 PSI.
Ford 9N makes 23 PTO horsepower on a good day. It can handle the second largest Prince pump that is rated at: 5.7 cubic inches per rev. At 2000 PSI, it needs 18 horsepower. At 2500 PSI it needs 24 horse. So, if you have a 3.5" or 4" cylinder, and this pump - you'll have pretty good cycle time and enough power to split just about anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
