|
Tractor Talk Discussion Board |
Re: Hand Clutch.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom from Ontario on November 19, 2000 at 17:12:15 from (216.129.12.167):
In Reply to: Hand Clutch. posted by Karl Bader on November 19, 2000 at 16:12:08:
On a lot of the older tractors, it was prefereable to drive standing up most of the time. On some of them, particularly the standard types was the only way you could see the ground in front of the tractor. On some of them, it was the most positive way to engage the clutch as they had a "snap-in" feature to keep the clutch fully engaged. Try the clutch on a two cylinder John Deere. They take a bit of an oof to fully engage. Allis Chalmers had both a hand clutch and a foot clutch. Took a bit of getting used to, but seemed absolutely logical after a while.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|