Posted by John T on July 23, 2009 at 04:22:31 from (66.244.97.31):
In Reply to: generator posted by Lightner on July 23, 2009 at 02:22:33:
As posted below, you need of course a 12 volt genny and 12 volt Voltage Regulator, the wiring changes will be minor,,, the wire that connects to the alternators big main output stud now wires instead to the BAT terminal on the new VR,,,,,,GEN/ARM terminal on VR wires to gennys ARM post,,,,,,,,,FLD terminal on VR wires to gennys FLD post. Be sure to Polarize the genny BEFORE you start her up. If it was already converted from Pos to Neg ground and has an ammeter its wires needed to be swapped or else it would read bass ackwards. If its a coil ignition instead of a Magneto, the coil is polarity sensitive and for neg ground its lil + gets ignition switched voltage while its lil - wires to distributor.
This cant be certain as I have no idea how its wiring was modified when it was converted to an alternator, so this is just a guide subject to what was done before mind you...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.