Tractor Talk Discussion Board |
Re: 8 volt battery question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Salmoneye on November 19, 2000 at 00:55:59 from (206.27.102.39):
In Reply to: 8 volt battery question posted by Mark Stanfield on November 18, 2000 at 19:07:32:
IMHO... Don't put the 8-volt battery in. You will fry your coil and your points quickly. When you do a 12-volt conversion, you are just trading one set of problems for another. What you need to do is fix the problems that you have with the 6-volt system. It may be that your battery is just old and weak. How big (thick) are your battery cables? They have to be at least 2 guage (mine are 1/0) to allow the needed amperage to flow. Buy or make yourself the shortest, fattest cables that will fit between the post and the connection! 6 guage Japanese car cables just won't cut it. Clean ALL your connections! They must be shiney, bright and tight in order to eliminate any resistance caused by corrosion. Do you have 'resistor' wires on your spark plugs? Junk them and get yourself some copper-core wires. They still make them and they are marketed to 'Hot-Rod' enthusiasts for 'High-Performance' vehicles. If you don't believe me, go to the N Board archives and read up on the troubles you will be getting into with an 8 volt battery...
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|