Posted by Buzzman72 on July 20, 2009 at 11:24:42 from (74.129.192.160):
In Reply to: Re: Mechanic Jobs posted by wayne in mn on July 20, 2009 at 11:01:53:
About tools: when I was at the vocational school in '06-'07, I discovered that Snap-On, Matco, S-K, and other tool sellers have a vo-ed [vocational education] program that allows students to purchase tools at a discount while they're in school. [Mac Tools doesn't,and I don't know why.] Snap-On's program allows you 50-55% off retail, with a maximum purchase of $5,000 [unless it's changed since then]. But it's run thru the regional rep, and NOT thru Snap-On's tool truck program. School officials can get all the details for you. It was nice to have the Snap-On and Matco tool reps actually show up at school and make a presentation about their programs.
But even at 50-55% off, $5,000 in tools is barely enough to get you started. Still, it beats paying $10-$11,000 for the same stuff off the tool truck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.