|
Tractor Talk Discussion Board |
Re: It's not a tractor BUT its a Farm Truck.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Salmoneye on November 17, 2000 at 02:11:54 from (206.27.102.38):
In Reply to: It's not a tractor BUT its a Farm Truck. posted by Canadian Cowboy on November 16, 2000 at 20:41:39:
Get a length of rubber fuel line and stick the end in a fresh gallon of gas and attach the other end to the inlet side of the pump. Detach the line into the carb and stick it in a 2 litre plastic soda bottle. Disconnect and ground the output wire from the coil to distributor (you do not want any sparks for this) and have someone crank the engine. You should see a strong pulsing into the soda bottle. If you do not, replace the pump. If there is gas coming out, take a pin and stick it in the hole where the line connects to the carb. I am unsure of the float needle configuration of your carb, but this works with many carbs as the needle valve is just inside that hole. You may be able to break the varnish seal on the needle and get it to allow the gas into the carb bowl. I have done this on quite a few different carbs.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|