Posted by bc on July 12, 2009 at 13:34:48 from (71.158.222.210):
In Reply to: HELP? posted by Allan In NE on July 12, 2009 at 09:24:47:
They make a good crack sealer used by a lot of foundation repair companies around here. Comes in a tube from Lowest and Home cheapo and other places. They use a high pressure caulking gun to push it into the crack. Clean the crack of loose stuff and maybe hit it with a grinder to widen the crack to give the compound a place to set. It's near impossible to do but a bell bottom crack will hold better.
Long term fix is to take your bucket or get a hoe and dig out the outside. Seal the crack from the outside like you did the inside. Then coat or recoat the outside wall with a foundation asphalt sealer. Check to see if the foundation is settling. Cinder block is porous but cracks usually occur along the mortar joints.
When you backfill, try to backfill a couple feet within the wall with some porous fill material such as sand so the water flows away from the crack instead of building up hydraulic pressure because of the wet expansion by clay which retains water and applies pressure to the wall making it crack.
Besides the slope and gutter ideas already mentioned, attribute this to the rainy year if this is a first time for the house and then don't put down any expensive bear skin rugs in the basement. I have one to fix out at the farm but it isn't in a living area and it really only leaks during a big rain. Have everything ready, just need a spare weekend to do it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.