I disagree. Snakes eat a lot of mice and other small critters. I have no quarrel with the snakes we have around here, as they are not dangerous to humans or dogs. They do a great service in helping to control vermin.
Luckily, we do not seem to have rattlesnakes in this area. I have lived on the same property for about 50 years and have never seen or heard a rattlesnake anywhere around here. I have seen several large Bull snakes over the years. They can be 6 feet long and about 2.5" thick and can be quite startling. I don't know how they might act if they were cornered, but when I have seen them, they were doing their darndest to get away from me. I have left them alone, and after I have seen them, the ground squirrel population in that area went down.
I would destroy any rattlesnake that I ever came across. They CAN cause great harm or death to people or pets. And I probably would kill a snake if I found one in or close around my buildings, but I never have. But the snakes that are not dangerous and are out on the property have nothing to fear from me, even if they startle me a little. They are doing a job that is useful to me. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
