Been there.On Delco 35MT starter on Farmall.But don't know if you have Delco on the Deere?? Now here is what we experience.New Reman starter this spring.Upon the machining of the 360 degree rotating (nose) or drive housing on flywheel end of starter.We notice a problem upon installing the starter.Very difficult to install the top bolt.(NO) room much for 9/16 wrench (box) end to get on bolt. The other 2 bolts was fine.BIG ???????? mark!!!
Ok after install NO GO!! Starter motor just fly lot of steel noise. We remove timing cover shine flash light in on top the flywheel to see what was going on.
Here is what we see. (top) part of starter drive gear riding on top of ring gear NOOOOOOOOO mesh at all.Rotating head on starter Machined off to one side.Other words mounting flange machined wrong.
Tell him to check tops of both gears see if the tops of the teeth are real shinny or fresh machining (LOOK)to them.If so rotating nose is machined wrong.Seen this one other time on a CASE 830.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gettin My Old Tractor Home - by Clayton Sweeney. My name is Clayton Sweeney. I am from Southern Maryland in a small town called Lothian. I am 20 and my father and I are the proud owner of a 1954 Allis Chalmers WD-45. When I was 18, I dated a girl in the next county over. Her family are tobacco farmers. It was a cold Thanksgiving evening, and we were going up to her Grandparents house. As we passed one of their barns, I noticed something orange in the corner of my eye in this old shed. It was pretty dark and I asked what it was
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
