Posted by Lanse on June 18, 2009 at 12:48:38 from (65.89.42.129):
In Reply to: Where'd Lanse Go? posted by OliverGuy on June 18, 2009 at 10:17:41:
Ive been on alot since last fall here and there!!
Ive also been on alot lately, just havent posted much. I havent done anything tractor realated since my visit up to R Aikin's place two weeks ago... That was fun!!
Its hay season.... And im stacking all the wagons i can find..... As well as doing whatever other odd jobs i can get around here.... But there arent as many as there were last year....
Ive been painting the B for two months now.... I put up a picture of it in primer on April 6. I had problems with moisture so i decided to wait until the spring was over. Filters and such cost money.... so i tried to avoid them at all cost....
I've started just running air through the whole system for like half an hour before i accually add paint... And that seems to work really well...
Getting my brush job off from a year and a half ago sure was a trick....
I took the never treated gas tank to the car wash and sprayed it out. There was a trail of rust coming from it when i was done.... Once it dries out im going to seal it myself...
I did end up buying that Welder....
And after reading the book Rich lent me... tried it out last night... She works pretty good!!! I need alot of practice, but its a skill worth learning....
This is the MTD mower i got from rich, along with two engines. She needs a carb and a mag
The purple truck is still kickin... Something aint right with the fuel tho... hopefully i just need to find and reset the fuel pump shut off switch once i find it....
We got it out for the first time this summer before i planted anything and took it for a joyride. It had one broken hanger.
It now has three...... lol....
So once i get this welding thing down im gonna try to make my own... its just a farm truck.....
The WC hasnt gotten much attention lately.... I only need rings and gaskets before i can out it back together...
The C still needs a manifold and front tires... plus i have to get the distributor working and rebuild the carb. I dont think i can do much with her until later on in the summer....
The corn really sucks as always... But its been too wet to cultivate it lately... so oh well...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
