Tractor Talk Discussion Board |
Re: Degreasing a tractor...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Salmoneye on October 16, 2000 at 05:33:32 from (206.27.102.8):
In Reply to: Degreasing a tractor... posted by Karl Bader on October 15, 2000 at 14:17:51:
I am stealing this from Zane on the N Board. I saw this done as a kid, but had forgotten it till I saw his post a few months back. It will take off the grease well, but will eat your paint right off too, so it may be a bit of overkill for you. You will need water, corn starch and Red Devil Lye. Zane's Recipe: "If any of you are interested here is the recipe for the stripper. Cheap too! You just use as much water as you want paint remover. A gallon will be a good amount to begin with to sorta experiment with. Add corn starch to the water FIRST till the water is the color of whole milk. Then stir in the lye slowly till the mixture begins to thicken. Add just enough to make it the consistency of thick gravy. Paint in on with a brush. Use safety glasses and gloves. It will sting if it is gotten on the skin but will not burn if rinsed off soon with lots of water. Vinagar will act as a neutralizer Let is sit on the tractor etc as long as possible without it drying out. Then wash off with the garden hose or a pressure washer if one is available. You can do it as many times as it takes to get it all cleaned off. It will not harm the wiring. The secret of sucess is the thickening that the corn starch contributes to the mixture. This allows it to stay where it is put and not run off and dry out too fast. Water and lye would do the same thing if it would stay put but it won't."
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|