|
Tractor Talk Discussion Board |
Re: Anyone know the correct way to jump start a 6volt 8N tractor from a 12volt vehicle
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pay attention here on October 11, 2000 at 13:57:04 from (207.177.47.143):
In Reply to: Anyone know the correct way to jump start a 6volt 8N tractor from a 12volt vehicle posted by Bill C. on October 10, 2000 at 21:36:16:
Bill- Please pay attention to the other posts here, about making shure the thing is in neutral. After you live thru a "close call" all your actions reflect it. That was a subtle part of my original reply. My experience is that the 6 volt system was the best the designers knew back in the bad old days. If you got a dead, or weak, battery quit screwing around and go get a new one! The procedure I described kept the lid on the battery and top cover and made you use the 8N neutral start safety switch. If the battery blew you'd be OK unless you were peeking down in there. The advise to connect the ground cable to a running board is good, cuz the 12 to 6 volt circuit then involves a lot of iron and rusty connections. That puts some resistance in the jumper circuit and reduces the chance of battery blow up. If you're into having a museum piece, buy a new 6 volt battery. If your 8N is a daily driver, get with the 12 volt program, like I did in 1972. It'll blow your mind, that the engine is running before you can let go of the starter button. Before I converted, every winter doing snow removal, I'd have to do starter repair or rebuild. After I did the 12 volt conversion, the thing ran for 15 years and I never had to mess with the starter, just bought a new battery about every 3 years. Good luck, IHank
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
