Tractor Talk Discussion Board |
Re: Stuck and stripped oil plug...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by hay on October 08, 2000 at 04:27:55 from (209.255.163.139):
In Reply to: Stuck and stripped oil plug... posted by Karl Bader on October 07, 2000 at 08:01:27:
i had an oil filter that was stuck on my 1984 diesel chevette and nothing short of a 24 inch pipe wrench would remove it. i would tighten the new oil filter by hand 3/4 turn past contact with the gasket( the gasket was oiled, of course) and when i went to replace the filter after 3,000 miles i had to dig out the pipe wrench again. go figger that one. i know that is not about your problem, but it seems that some thing just will not work right no matter what u do. just my 2 cents worth. LOL.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|