Posted by J.ReinkeFarms on June 06, 2009 at 08:56:23 from (209.40.214.110):
In Reply to: soybeans how to ? posted by gtx1967jewison on June 06, 2009 at 08:25:38:
With soybeans your planting depth isn't too critical. From the National Soybean Institute
Seeds should be planted deep enough to meet the moisture and temperature requirements for germination. Planting depth may be determined by variety, and some varieties can emerge from greater depths than others (usually the larger seeded varieties). Typical planting depths are 1-1.5 inches, but if soil is low in moisture or sandy, plant 2 inches deep. In cool, moist soil, seed can be planted 1 inch deep. Seldom should soybeans be planted deeper than 2.5 inches.
Back in the day I remember in the tire tracks our old CaseIH drill wouldn't even put the seeds in the ground, just set them in a groove. Usually half those would still come up... then we ran down those same rows to spray and killed most of them anyway.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
