Is it normal practice to load hay on your place using your equipment (versus the customer bringing his own loader)? If it is, then I would think partial compensation would be fair but not necessarily required. Around here, a seller would be expected to provide his own operator for his own equipment. If you loading is an exception I would push for at least half or better. Generally, around here borrowing is kept to a minimum (run your old junk and be proud of what you have) and tractors usually go out with owner operating it. Either pay cash for the time or trade some of your equipment time in return. I've done both. I would go the body shop route (maybe 150 dollars) and not push the issue too hard to preserve goodwill. I would agree with those that say that being a hard head might make a person feel superior in the short term, but somewhere down the line the shoe may be on the other foot. You may need something from him or someone else and that gesture of goodwill will do a lot for a person's reputation. There is a fellow in the community here that will not do anything for anybody and at his age he is going to need to start leaning to others and it has been well discussed in the community the brush off some will give when that day comes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.