Posted by hal of Washington on June 03, 2009 at 22:51:33 from (208.81.157.90):
In Reply to: Pole Barn posts posted by 7lazy77 on June 03, 2009 at 08:17:00:
I sure wouldn't go to all the trouble of digging the deep post holes a pole barn needs and then put untreated pine in them. When I was a kid, we tried a few pine fence posts made from Ponderosa Pine trunks that grew on our ranch. Untreated, they often rotted and fell over in 3 or 4 years. Soaked in crankcase oil with some Penta, they might last about 10 years. Some of our treated Cedar posts are still holding up fences more than 40 years later, and the part down in the ground still is pretty sound.
You must not have building codes where you are. I doubt that any building inspector would allow untreated pine touching the ground. It rots too fast.
I would spend the money to buy good treated pole barn poles that will probably last longer than you do. Building a pole barn is too much work to do a substandard job that will not last. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
