Posted by Buzzman72 on June 02, 2009 at 09:45:34 from (74.129.192.160):
In Reply to: Welding helmets posted by rhouston on June 02, 2009 at 09:35:07:
The "blinker" can, indeed, go bad. The worst problem I had with my helmet [a Jackson, new in 2000] was the on-off switch not wanting to operate after a few thousand times. Not sure what you have, but on mine I can adjust the sensitivity--something I learned to do after a strobe light on a robot caused my "blinker" to cycle off and on while welding inside the frame plant.
Mine also has an adjustment for the shade [I think the choices are 9 to 13], as well as the speed at which it darkens/lightens. In 2000, retail on my helmet was around $280...not sure what a comparable helmet sells for today.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
