Careful- Pick the wrong day and we'll put you to work baling hay. I pulled the old Fox 3000 out tonight and found a hole in the pan under the knives that goes to the blower. I got out some more poly that we had in the shed and made that fit.
Gotta find a new window motor for the spout. The one on it now is about junk. I got it out of a early 90's S10 about 5 years ago- think I'll call a couple junk yards and the autoparts store and see what a new one will cost.
I'll look into sharpening the knives and adjusting the shear bar. I'll look it over a little more and hopefully nothing else pops up. I'm hopeing there's nothing wrong with the haybine, because I'm hoping to cut on Wednesday if the forecast stays clear through the weekend.
You're in Depere right? I live in an apartment on the north side of Kaukauna so I'm probably closer yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.