Posted by Paul in MN on May 31, 2009 at 08:36:31 from (71.210.144.244):
In Reply to: Re: ford truck posted by massey333 on May 31, 2009 at 07:53:49:
Massey,
Yes, I did think about the possibility of it being a Dana 70, and I think you are right. The HD Fords of that time period were stout. But as I had written a lot of info, and I type miserably slow, I decided to not add any more "confusion". The procedures I described are exactly the same for the Spicer (Dana) 60 and 70. If I recall correctly, the Dana 70 has bigger wheel bearings, and maybe a larger ring and pinion gear. I am pretty sure it has heftier axle tubes. I do not know if all F350s of that time used the Dana 70, or maybe just the heavy pullers having the 460 engine. It has been a lot of years since I worked on a 1975 Ford!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
