bc said: (quoted from post at 20:00:51 05/29/09) I knew a welder who could weld on a live 8" lpg propane gas lines. Not sure what he was doing or why, but as long as he didn't burn through. I think he was welding on or around well heads for underground storage wells. Plus propane is cold anyway.
So far as I know, all or most all taps are done on live lines. I serviced HVAC here locally for nearly 15 years, and now there's more and more plastic, but where there's metal, they weld taps on "live."
I think most city street service stuff is 120-250 lbs. The line coming past my folks semi-rural home is the main feed for my small hometown. I believe it's up around 500 psi or so. For many years, "they" would not tap individual homes off that main line. This comes from the big big really big Canadian tube I mentioned earlier.
When I went to "gas" school, the local (Spokane) then Washington Water Power, had a section of large plastic, maybe 3"? or so, someone had driven a standard 8' ground rod right through the middle of the thing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
