Posted by mike in new mexico on May 29, 2009 at 13:05:53 from (206.206.84.220):
Hello, was investigating my vacuum lines and discovered a line that is disconnected. My transfer case is the NP 231-D and on the top is 4 vacuum lines: 2 to the vacuum actuator, 1 from the engine vacuum, and a fourth line that is hard plastic that is in the vacuum harness but not connected to anything. The other end is connected to the top of the transfer case. My question is, where does this fouth line connect to. The end appears burned off possibly from exhaust manifold but its just hanging loose. The 4-wheel drive seems to work but I would like to know where this line is supposed to plug into on the firewall side. I cant find any ports that is not used on the motor side and the motor runs excellent.
Any help anybody can give me, I would sure appreciate it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
