Posted by OliverGuy on May 25, 2009 at 19:33:57 from (75.149.65.181):
In Reply to: duramax mileage? posted by Brad in WI on May 25, 2009 at 19:00:36:
Depends on what year. "04 and early is a 5 speed and "05 and later is a 6. Wish my "04 had that next gear. It"s humming down the road past 60 and uses way too much fuel. Those motors only barely need to be turning over to run down the interstate. Rear end ratio obviously matters also. We pull trailers every day and I would keep buying 8.1"s if they made them. Everything I have gets 8 mpg while pulling--8.1"s, 6.0"s, 350 Vortecs. But the 8.1"s pull 10,000 lbs. or more with ease. But if you"re not pulling all the time, the 8.1 gets really thirsty. Only GM"s here also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
