Posted by John B. on May 24, 2009 at 19:33:36 from (38.114.64.193):
In Reply to: INT 574 posted by Kenstrac on May 24, 2009 at 08:48:11:
That series tractor likes to burn valves. If the brakes fade just put new kits in the master cylinders. They all had wiring issues to the lights.
I have a 574 and wouldn't trade it. I gave $4,700.00 for mine and it needed a valve job when I bought it. They wanted another $700 to do the valve job but I did it my self and glad I did. When I pulled the head it needed new pistons also. I put new pistons, rings rod and main bearings and had valve job and new springs installed on the vavles plus all the needed gaskets for $700.00.
I see a lot of Kubotas out there but I've been inside of them also and they are just an oversized garden tractor as far as I'm concerned.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
