Posted by rrlund on May 21, 2009 at 16:56:19 from (216.46.211.175):
I don't have a stake in this,but I wanted to give this guy a good word. There's a place called Andrews Engineering and Machine on M57,three and a half miles west of 127. I saw his ad in the Farm Trader. For the heck of it,I took two rollers out of the round baler over that had had bearings go out and scored the shafts. He said he could weld them up and turn them back down. I went and got them today. He built up BOTH ends of one and one end of the other for $35 per end! Unbelieveble! He had a shaft there out of a combine grain head that must have been 10-12 feet long and he said he built that one up and turned it down for $35. Check this guy out,he has a web site. Just Google it. It'd sure be nice to keep this guy in business.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
