Posted by ChrisinMO on May 12, 2009 at 11:53:16 from (75.120.189.146):
In Reply to: Best manure choice?? posted by bruster on May 12, 2009 at 11:28:10:
Sorry that I don't know where you're located.
As for manure, you're going to get weed seeds in any and all of it, especially if fresh. Composting the manure can help, especially if you can get the compost pile really heated up well. I've used manure in compost, even when I knew there would be weed problems. I figured that the enhanced fertility was worth the trade off on weeds. The only requirement is to make sure to stay on top of the weeds as soon as they germinate. Let them get going and they'll make a crop of their own.
Something you can do about the clay, to some degree, is planting cover crops. Buckwheat is known to smother weeds and I've heard that it also helps loosen up compacted soils. Sweet clover can really break up hard pans, especially if you let it get growing the second year and only till it in after full bloom. The best way to handle soil compaction in a garden is to add organic matter and then don't fool with the soil any more than necessary. The earthworms and bacteria, et al, will loosen things up in due time as long as you keep them fed.
There are some things you can add to the soil in place of manure, without all the weed problems. Mulching with grass clippings will help smother weeds and add fertility to your garden. Mulching with shredded leaves in the fall will protect the soil in winter and gradually rot into the soil, enriching it. If you don't have a shredder, just spread the leaves on the garden and till it in during the fall to keep the wind from blowing them away.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
