It depends on what you can find in your area. So I would suggest looking at some tractors, wherever you can find them. You might want to look at the bulletin board at the local farm and feed store, and the various shoppers that are free in most places.
I have a couple of old Ford hundred series tractors and I like them, partly because I am fairly familiar with them. And one of them was my Dad's last tractor. They have been pretty good and they work fine with most 3 point implements.
However my neighbor has a Kubota 4 wheel drive that really impresses me. He has never bothered with chains, while my 2 wheel drive tractors are almost useless in snow and ice without them. The Kubota also will go extremely slow and has a live PTO, both of which make it work great to run a rear snowblower attachment. While I would not rule out any tractor, I would bet that the next one I buy will have 4 wheel drive, live PTO and will be able to go a lot slower than my Fords will.
The Ford N's are neat little tractors, but they are not nearly as powerful as the later models and do not have live hydraulics. On the other hand, I think they are supported by the aftermarket better than just about any old tractor. Virtually anything you need to fix one, or keep one running is available. They also are pretty simple and straight forward to work on. And there are still many thousands of them out there available. An N might work out just fine for you.
But there are lots of tractors to consider. For a working tractor, I would not consider a real orphan that would be hard to get parts for, but most any of the tractors from the 50's through 70's from the major manufacturers might be OK.
See what you can find, and then study up on that model. These boards have a ton of information. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
