Posted by MF Poor on April 30, 2009 at 13:04:21 from (98.19.88.232):
In Reply to: Pull Disc vs 3-point posted by fregienewbee on April 30, 2009 at 04:26:47:
There's only a very small handful (if that many) 3-point disc's that are worth there weight in peanuts. Most are a waste of time IMHO. The ones that ARE worth having are limited to a couple older designs and a few new VERY expensive VERY heavy models. Best ever in my opinion, the model #25 Massey Ferguson disc. (Easily identifiable by the pair of gang adjustment levers near the 3-point top link hitch mast. ) Ford made a decent model back in the day (flex hitch)
A wheel disc is tough to beat IF you have remote hydraulics to run a cylinder. My favorites are IH models built in the 60's and 70's.
It's hard to beat the mobility and manueverability of a GOOD 3-point disc, especially so with smaller tractors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Best Tractor? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew quite a bit of response. We see the question of "Which tractor is best for me?" asked quite often. We thought you might find the responses interesting. As always, the names of the people participating in the discussion have been left out - we did not request their permission to reprint their names in this article. However you can find this discussion in it's entirety in the Tractor Talk archives.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
